UP
DN
1
1. Power trim and tilt switch
UP
DN
1
1. Power trim and tilt switch
EMU26156
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on
the side of the bottom cowling. Pushing the
switch "
" (up) trims the outboard motor up,
and then tilts it up. Pushing the switch "
(down) tilts the outboard motor down and
trims it down. When the switch is released,
the outboard motor will stop in its current po-
sition.
For instructions on using the power trim and
tilt switch, see page 59.
EWM01032
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
falling overboard and could distract the
operator, increasing the risk of collision
with another boat or an obstacle.
UP
DN
1. Power trim and tilt switch
EMU46741
Tiller handle operation
This outboard motor can also be operated
using a tiller handle. For details about the tiller
handle, consult your Yamaha dealer.
"
EMU26246
Trim tab with anode
EWM00841
An improperly adjusted trim tab could
cause difficult steering. Always test run af-
ter the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
Components
1
ZMU08528
31