Table of Contents
Advertisement
Basic components
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
NOTE:
The engine cannot be started with the clip re-
moved.
1. Cord
2. Clip
EMU26011
Choke knob for pull type
To supply the engine with the rich fuel mix-
ture required to start, pull out this knob.
EMU26090
Main switch
The main switch controls the ignition system;
its operation is described below.
18
"
G
With the main switch in the "
tion, the electrical circuits are off, and the key
can be removed.
"
" (on)
G
With the main switch in the "
tion, the electrical circuits are on, and the key
cannot be removed.
"
G
With the main switch in the "
sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
EMU32051
Power trim and tilt switch on remote
control
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch "
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position.
NOTE:
For instructions on using the power trim and
ZMU03903
tilt switch, see pages 39 and 41.
" (off)
" (start)
" (on) position.
" (down) tilts the outboard
" (off) posi-
" (on) posi-
" (start) po-
" (up) trims the
Advertisement
Table of Contents
