Kurzweil X-Pro Series Getting Started Manual page 52

Song Mode
6.
Note: Most users will want to store initial values as described above. Advanced users may not want to
store initial values for every track. See the PC3 Musician's Guide, Chapter 12, Song Mode:The MAIN
Page, Program, Volume, and Pan sections for details on saving an initial value for a single track only.
Part 6 b: Recording Volume Automation
You can also record volume automation. Volume automation is the method of recording a series
of volume event messages that change a track's Vol parameter over the course of the song. This
is useful for fading instruments in or out of a song, or adjusting instrument volumes for only
specific sections of a song.
1.
2.
3.
4.
Part 6 c: Erasing Volume Automation
If you've saved a song with volume automation and you wish to change or remove it
afterwords, follow the steps below to erase a selection of volume automation:
5-12
Follow the above procedure in steps 4 and 5 to store current values as initial values after changing
any volume, pan, or program parameters.
On the Song mode MAIN page, make sure the Mode parameter is set to Merge (see below.) (Also
make sure the Punch parameter has been turned off, as in Part 5, step 9, above.)
Press the Record button, then press Play/Pause.
Select the Vol parameter and adjust it with the alpha wheel while the sequencer is recording. Any
changes to the Vol parameter will be recorded as data in the current track.
When you are finished, press the Stop button. You will be able to review and save your changes just
as in Step 4 of Part 3 (see above.)