The Setup Editor - Kurzweil X-Pro Series Getting Started Manual

Setup Mode

The Setup Editor

The Setup Editor
In each of the following guides, you will be using the Setup Editor to make changes to the currently
selected setup. Open the Setup Editor from Setup mode by pressing the Edit button on the front panel.
Use the soft buttons at the bottom of the display to select the various Setup Editor pages. Use the more
soft buttons on the bottom of the display to scroll to through pages of soft buttons. The top line of the
display says "SetupMode:" with the name of the current Setup Editor page as well as the
number of the current zone. Use the Chan/Layer buttons to the left of the display to select the
current zone. The current and total number of zones can be viewed in the upper right corner of
each screen in the Setup Editor.
Press the Exit button on the front panel to exit the Setup Editor and return to the Setup mode main page.
If you have made any changes to the setup, you will be presented with the message "This setup has been
edited..." (see below.) You are given a choice of soft buttons: Press Rename to rename the setup before
saving, press No to return to the Setup mode main page without saving, press Yes to choose an
ID# and save the setup, press Cancel to return to the Setup Editor.
When saving, you must choose an ID#. An ID# gives you a way to locate a setup aside from its
name (you can store up to 2,048 unique ID#s for each object type: setups, programs, songs, etc.,
though many ID#s are already used for factory ROM objects.) ID#s also allow you to save
setups with the same name under different ID#s, and rename them at a later time if desired.
Choose an unused ID# to save a new setup. The next available unused ID# is automatically
selected when editing a factory ROM setup. When editing a setup that has been stored in user
memory (any originally unused ID#,) the edited setup's ID# is automatically selected. This
assumes that you wish to replace the existing setup, but you can choose another ID# if desired
to save a new copy. Choose a used ID# to replace an existing saved setup. If you replace a
factory ROM setup, you can revert to the original setup by using the Delete soft button in the
Setup Editor. See the PC3 Musician's Guide, Editing Conventions chapter for more details on
saving and naming.
4-2