Effects - Kurzweil X-Pro Series Getting Started Manual

Program Mode

Effects

Effects
Many programs are saved with effects, such as reverb, distortion, or delay. In Program mode
you can adjust the level or intensity of these effects by using the X-Pro's nine sliders. Below is a
list of the X-Pro's sliders identified by letter. By default each slider will control a parameter as
listed below (if the parameter is in use in the current program.)
A
B
C
D
E
F
G
H
I
In Program mode you can press the Info soft button to see controller assignment information for
each program. Pressing the Info soft button brings you to the Program Information page, which
will display any available controls for the current program's effects or other aspects of the
program. On the Program Information page, sliders and buttons will be listed with their
function, if they have a function assigned to the current program. Some programs have more
controls than can fit in the display, in these cases there will be a scroll bar icon on the right of the
display. Use the alpha wheel to scroll through additional pages of controller assignments.
To learn more about the X-Pro's effects and Effect mode, see the PC3 Musician's Guide, Chapter 9.
To learn more about the assigning controllers to effects and other parameters, see the PC3
Musician's Guide, Chapter 7, The Control Setup section. For information on assigning or editing a
program's effects, see the PC3 Musician's Guide, Chapter 6, The Program FX (PROGFX) Page.
3-4
Filter frequency, Brightness
Filter resonance, Tremolo rate control
Layer volume, Envelope control, Lo EQ
Layer volume, Envelope control, Hi EQ
Layer volume for thumps and release
FX control 1
FX distortion drive
FX distortion warmth
Reverb / delay control