Creating A New Setup - Kurzweil X-Pro Series Getting Started Manual

Creating A New Setup

Follow these steps if you would like to create a new setup from a blank template.
1.
2.
3.
4.
If you are not already in Setup mode, press the Exit button until you reach the ProgramMode page,
then press the Setup mode button, located with the mode buttons to the left of the display. This will
bring you to the Setup mode MAIN page (see below.)
Use the plus/minus buttons or alpha wheel to select the setup 128 Default Setup or use the
alphanumeric pad to enter 128 and press Enter (see below.)
With the setup 128 Default Setup selected, press the Edit button on the front panel. This will
bring you to the CH/PROG page of the setup editor (see below.)
On the CH/PROG page, select the Program field (see above.) Select a program for zone 1 using the
plus/minus buttons, the alpha wheel or the alpha numeric pad. You can also use a combination of
Bank, Category, and Program buttons to select a program.
Setup Mode
Creating A New Setup
4-11