Table of Contents
Advertisement
Number of Mounting Holes ............................ 2
Diameter of Mounting Hardware Needed ..
To mount the sharpener:
1.
Place base flat on workbench, slide it back
until stop flanges (see Figure 15) hit front of
the workbench.
Angle
Knob
Figure 15. Stop flange against the workbench.
2.
Mark mounting hole locations and move base
to side.
3.
Drill holes in workbench surface.
4.
Re-position base over holes and use appro-
priate hardware to securely mount base to
workbench using Through Mount or Direct
Mount techniques (see Figures 13 and 14 on
Page 14).
Model T28959 (Mfd. Since 2/19)
3
Stop
Flange
Base
⁄
"
8
The Model T28959 is shipped partially assem-
bled. Perform the following procedure to complete
the assembly.
To assemble the sharpener:
1.
Thread depth stop knob assembly into hole
on swing arm (see Figure 16).
Figure 16. Depth stop knob assembly.
2.
Remove angle knob from chain holder
assembly (see Figure 17).
3.
Attach chain holder assembly to base (see
Figure 17).
4.
Secure chain holder assembly to base with
angle knob (see Figure 17).
Base
Figure 17. Attaching chain holder assembly to
Assembly
Depth Stop Knob Assembly
Chain
Holder
Assembly
base.
Swing Arm
Angle
Knob
-15-
Advertisement
Table of Contents
