3.
Connect the router to Port 2, 3, or 4 on the Audio Network Interface
4.
Connect the Access Point Transceiver to the Port 1 of the Audio Network Interface.
5.
Connect the Network Charging Station(s) to an open port(s) on the Audio Network Interface.
6.
Repeat steps 2 - 4 for additional equipment.
Rack Installation
Rackmount the device using the screws and washers supplied in the Hardware Kit. Follow these general best practices when
installing equipment in a rack:
•
Ambient temperature of the rack should not exceed specified operating temperature range of the device.
•
Keep fan inlet and side air vents clear from obstructions and provide adequate space for airflow within the rack.
•
When possible, provide 1 RU of empty space between each device.
Securing the Charging Station
This kit provides washers and screws for securing a charging tray to a table or other surface. Use two kits for the NCS8.
Please refer to the NCS mounting template for screw hole placement.
Important: The top of the screw must extend exactly ⁹/₆₄ (0.149) inches (3.78 mm) above the surface (about 4½ threads).
•
Use the screws that best fit the thickness of the table.
•
Use a lock washer and flat washer for each screw.
•
If necessary, counterbore the screw head or add additional flat washers.
Shure Incorporated
32/103