Table of Contents
Advertisement
TRENDnet User's Guide
Hardware Reset Button
The hardware reset button is located next to the Micro‐SD card slot. To reset
the camera to factory default settings using the hardware reset button:
1. Disconnect the camera from its power source.
2. Press and hold the reset button BEFORE you connect the camera to
its power source.
3. Continue to hold the reset button for at‐least 15seconds.
4. Your camera should now be reset to factory settings.
© Copyright 2019 TRENDnet. All Rights Reserved.
Warnings
Serious injury or death may be caused if any of these warnings are neglected.
Follow these safety guards to prevent serious injury or death.
• If using the power adapter, please choose the power adapter that
meets the safety extra low voltage (SELV) standard or IEC60950‐1 and
Limited Power Source standard.
• If the product does not work properly, please contact your dealer or
the nearest service center. Never attempt to disassemble the camera
yourself. Disassembling the product will void the warranty and may
cause harm or injury.
• To reduce the risk of fire or electrical shock, do not expose this product
to rain or water.
• The installation should be done by a qualified service person and
should conform to all construction and electric regulations and other
local codes.
TV‐IP460PI
4
Advertisement
Table of Contents
