TRENDnet User's Guide
Preset Status: Set the preset name display duration as 2 seconds to
10 seconds, NC (Normally Closed) or NO (Normally
Open).
POWER OFF MEMORY
Set Resume Time
The camera can resume its previous PTZ status or
Point:
actions after it is restarted from a power‐off. You can
set the time point of which the camera resumes its
PTZ status from 30 seconds up to 600 seconds or
disabled before power‐off.
Click Save to save the changes
© Copyright 2019 TRENDnet. All Rights Reserved.
Limit
Steps
1.
2.
3.
The camera can be programmed to move within the configured
stops. (left, right, up or down)
Check the Enable Limit box and select Manual Stops or Scan Stops from
the Limit Type list.
a. When manual limit stops re set, you can operate the PTZ control
panel manually only in the limited area.
b. When scan limit stops are set, all the scan actions are
performed only in the limited area.
Click the PTL control buttons to find the left/right/up/down stop limits,
you can also call the presets and set them as the limits for the camera.
Click Set to save the limits and Clear to clear the limits.
TV‐IP460PI
61