Table of Contents
Advertisement
Introduction
1.1 Introduction
Standards and Approvals
SCALANCE X101-1AUI meets the requirements for the CE mark. For detailed information
please refer to the chapter "Notes on the CE Mark" of this commissioning manual.
The SCALANCE X101-1AUI media converter meets the requirements for the UL , C-Tick ,
FM and ATEX marks . For detailed information please refer to the technical specifications in
the "Approvals" heading of this commissioning manual.
What Is Possible?
The SCALANCE X-101-1AUI device enables the cost-effective installation of Industrial
Ethernet bus and star structures with a media transition.
Note
It is not possible to use a SCALANCE X101-1AUI media converter in a redundant ring since
it does not support the redundancy function.
Note
The requirements of EN61000-4-5, surge test on power supply lines, are met only when a
Blitzductor VT AD 24V type no. 918 402 is used
Manufacturer:
DEHN+SÖHNE GmbH+Co.KG Hans Dehn Str.1 Postfach 1640 D-92306 Neumarkt,
Germany
Warning
When used under hazardous conditions (zone 2), the SCALANCE X101-1AUI media
converter must be installed in an enclosure.
In the scope of ATEX100a (EN 60079-15), this enclosure must at least comply with IP54
according to EN 60529.
WARNING – EXPLOSION HAZARD: THE DEVICE MUST ONLY BE CONNECTED TO OR
DISCONNECTED FROM THE POWER SUPPLY IF AN EXPLOSION HAZARD CAN BE
DEFINITELY EXCLUDED.
Note
The specified approvals apply only when the corresponding mark is printed on the product.
1-2
Industrial Ethernet Media Converters SCALANCE X-100 Series
Commissioning Manual, 06/2006, A2B00051526A, Product Version 03
Advertisement
Table of Contents
