Table of Contents
Advertisement
The settings here are special settings that are unnecessary during normal use. The stick mode can be
changed and stick adjustment (calibration), throttle lever reverse, and language can be set.
TX SETTING
STK-MODE
STK-ADJ
THR-REV
LANGUAGE
■ STK-MODE
RUD
AIL
ELE
THR
MODE 1
RUD
AIL
ELE
THR
MODE 3
■ STK-ADJ
This function is normally not used. If stick deviation should occur, make this adjustment.
Do not use it in the normal state.
Calling the setting screen
① Turn off the power and then
turn the power back on while
pressing the + key and – key
simultaneously.
＋
－
Stick adjustment
① Select the stick you want to
adjust with 1 〜 4 with the +
key.
＋
174
TX SETTING
1
NEXT
NOR
English
RUD
AIL
THR
ELE
MODE 2
RUD
AIL
THR
ELE
MODE 4
② Select STK-ADJ → NEXT
in the menu with the Jog
key.
② Press the Jog key down
and select NEUT ■ .
1
4
3
2
Turn on the power switch with the + key
and – key pressed in the power off state. The
screen shown at the left appears. To return
to the home screen, turn off the power
and then turn the power back on without
pressing the keys.
This is the MODE1 〜 MODE4 setting. The
initial state is MODE2. To change the mode
the stick ratchet must be changed. Request
that this be done by Futaba Service. (Charged
modification)
③ Enter the setting screen by
pressing the Jog key.
③ Set the stick to the neutral
position and press the Jog
key.
Advertisement
Table of Contents
