Host-To-Mps Communications; Mps Switcher-Initiated Messages - Extron electronics MPS 601 User Manual

Media presentation switcher
Hide thumbs Also See for MPS 601:
Table of Contents

Advertisement

4.
5.
6.
7.

Host-to-MPS Communications

The MPS switcher accepts Simple Instruction Set (SIS) commands through the RS-232 and
USB configuration port. SIS commands consist of one or more characters per command
field. They do not require special characters to begin or end the command character
sequence. Each response to an SIS command ends with a carriage return and a line feed
(CR/LF = ] ), which signals the end of the response character string. A string is one or more
characters.

MPS Switcher-initiated Messages

When a local event occurs, such as a front panel operation, the MPS switcher responds
by sending a message to the host. The MPS 601-initiated messages are listed below
(underlined).
Boot-up messages
(c) Copyright 20 nn, Extron Electronics, MPS 601, Vx.xx,nn-nnnn-nn
The copyright message is initiated by the switcher when it is first powered on.
firmware version number followed by the build,
The following dialog box opens (see figure 43):
Found New Hardware Wizard
Welcome to the Found New
Hardware Wizard
This Wizard helps you install software for:
Extron USB Device
If your hardware came with an installation CD
or floppy disk, insert it now.
What do you want the wizard to do?
1 1
Install the software automatically [Recommended]
Install from a list or specific location [Advanced]
Click Next to continue
Figure 43.
Install the Software Automatically
Select Install the software automatically (Recommended) (
NOTE: You do not need to insert an installation disc.
Click Next (
).
2
The PC locates the driver and installs it.
NOTE: The wizard opens only on the first occasion you connect the MPS 601 to
a USB port. The wizard reopens only if you connect the MPS 601 to a different
USB port or if you connect a different piece of equipment, requiring a different
driver, to the same USB port.
When the Completed dialog box opens, click Finish to close the wizard.
Configure the MPS 601 as required.
2 2
Next >
Cancel
.
nn-nnnn-nn
MPS 601 • Remote Communication and Control
).
1
]
is the
Vx.xx
39

Advertisement

Table of Contents
loading

Table of Contents