Step 4: Connecting The Audio Cords; Audio/Video Cord (Pinplug 3 Y Pinplug 3) - Sony RDR-GXD500 Operating Instructions Manual

manual\Final\218839311_FM\01GB04BAS.fm
01GB01.book Page 17 Mardi, 7. septembre 2004 9:41 09

Step 4: Connecting the Audio Cords

Select one of the following patterns A or B, according to the input jack on your TV monitor, projector,
or AV amplifier (receiver).
This will enable you to listen to sound.
R AUDIO
AERIAL
IN
OUT
DIGITAL OUT
COAXIAL
PCM/DTS/MPEG/
DOLBY DIGITAL
OPTICAL
Optical digital cord (not supplied)
[Speakers]
Rear (L)
Front (L)
Centre
: Signal flow
* The yellow plug is used for video signals (page 14).
z Hint
For correct speaker location, see the operating instructions supplied with the connected components.
Note
Do not connect your TV's audio output jacks to the LINE IN (AUDIO L/R) jacks at the same time. This will cause
unwanted noise to come from your TV's speakers.
D:\DVD
(red)
Audio/video
cord (supplied)
(white)
(yellow)*
LINE 2 OUT
L VIDEO S VIDEO
to LINE 2 OUT (R-AUDIO-L)
LINE 1 - TV LINE 3
LINE 4 IN DIGITAL OUT LINE 2 OUT
COAXIAL
R AUDIO L VIDEO S VIDEO R AUDIO L VIDEO S VIDEO
PCM/DTS/MPEG/
DOLBY DIGITAL
OPTICAL
to DIGITAL OUT (COAXIAL or
OPTICAL)
or
to optical
digital input
AV amplifier (receiver)
with a decoder
master page=right
(yellow) INPUT
VIDEO
(white)
L
AUDIO
(red)
R
TV, projector, or AV
amplifier (receiver)
COMPONENT
VIDEO OUT
Y
P / C
B B
P R / C R
~
AC IN
DVD recorder
Coaxial digital cord
(not supplied)
to coaxial
[Speakers]
digital input
Rear (R)
Front (R)
Subwoofer
A
B
17
,continued
RDR-GXD500
2-188-393-11(1)