Controlling Tvs With The Remote - Sony RDR-GXD500 Operating Instructions Manual

manual\Final\218839311_FM\01GB04BAS.fm
01GB01.book Page 20 Mardi, 7. septembre 2004 9:41 09

Controlling TVs with the remote

You can adjust the remote's signal to control your
TV.
If you connected the recorder to an AV amplifier
(receiver), you can use the supplied remote to
control the AV amplifier's (receiver's) volume.
Notes
• Depending on the connected unit, you may not be able
to control your TV or AV amplifier (receiver) with
some or all of the buttons below.
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote, the code
number may be reset to the default setting. Set the
appropriate code number again.
1
4
Number buttons,
7
SET/-/--
1
Slide the TV/DVD switch to TV.
2
Hold down [/1.
3
Enter your TV's manufacturer code (see
"Code numbers of controllable TVs"
below) using the number buttons.
4
Release [/1.
When the TV/DVD switch is set to TV, the
remote performs the following:
[/1
2 (volume) +/–
PROG +/–
t (TV/video)
Number buttons and
SET, -/--*
20
D:\DVD
TV/DVD
switch
"/1
2 3
PROG +/–
5 6
8 9
2 +/–
0
t, TV/DVD
Turns your TV on or off
Adjusts the volume of your
TV
Selects the programme
position on your TV
Switches your TV's input
source
Selects the programme
position on your TV
* If you use the number buttons to select the TV's
programme position, press -/-- followed by the number
buttons for two-digit numbers.
To operate the TV/DVD button
(for SCART connections only)
The TV/DVD button switches between the
recorder and the last input source selected on the
TV. Point your remote at the recorder when using
this button. The button works even if the TV/DVD
switch is set to DVD.
When you connect the recorder to the TV via the
SCART jacks, the input source for the TV is set to
the recorder automatically when you start
playback. To watch another source, press the TV/
DVD button to switch the TV's input source.
Code numbers of controllable TVs
If more than one code number is listed, try
entering them one at a time until you find the one
that works with your TV.
Manufacturer Code number
Sony 01 (default)
Aiwa 01 (default)
Grundig 11
Hitachi 23, 24, 72
Loewe 06, 45
Nokia 15, 16, 69, 73
Panasonic 17, 49
Philips 06, 07, 08, 23, 45, 72
Saba 12, 13, 36, 43, 74, 75
Samsung 06, 22, 23, 71, 72
Sanyo 25
Sharp 29
Telefunken 12, 13, 36, 43, 74, 75
Thomson 12, 13, 43, 74, 75
Toshiba 38
LG 06
JVC 33
master page=left
RDR-GXD500
2-188-393-11(1)