Table of Contents
Advertisement
manual\Final\218839311_FM\01GB04BAS.fm
01GB01.book Page 24 Mardi, 7. septembre 2004 9:41 09
10
Press ENTER.
The Setup Display for selecting the type of
video signal output from the LINE 1-TV jack
appears.
EASY SETUP
Select the Line1 output signal.
Video
S Video
RGB
11
Select the type of signal you want to output
from the LINE1-TV jack.
"Video": Outputs video signals.
"S Video": Outputs S video signals.
"RGB": Outputs RGB signals.
Note that if you select "On" in step 9, you
cannot select "RGB."
• If you select "S Video" or "RGB,"
SMARTLINK will be deactivated.
12
Press ENTER.
The Setup Display for selecting the type of
jack used to connect to your amplifier
(receiver) appears.
EASY SETUP
Is this recorder connected to an amplifier (receiver)?
Select the type of jack you are using.
Yes :
LINE2 OUT(R-AUDIO-L)
Yes :
DIGITAL OUT
No
13
Select the type of jack (if any) you are
using to connect to an amplifier (receiver),
and press ENTER.
If you did not connect an AV amplifier
(receiver), select "No," then go to step 16.
If you connected an AV amplifier (receiver)
using just an audio cord, select "Yes: LINE 2
OUT (R-AUDIO-L)," then go to step 17.
If you connected an AV amplifier (receiver)
using either a digital optical or coaxial cord,
select "Yes: DIGITAL OUT."
24
D:\DVD
Line1 Output
4/5
Audio Connection
5/5
14
Select the type of Dolby Digital signal you
wish to send to your amplifier (receiver).
EASY SETUP
Audio Connection
Dolby Digital
D-PCM
Dolby Digital
If your AV amplifier (receiver) has a Dolby
Digital decoder, select "Dolby Digital."
Otherwise, select "D-PCM."
15
Press ENTER.
The Setup Display for the DTS signal appears.
EASY SETUP
Audio Connection
DTS
On
Off
16
Select whether or not you wish to send a
DTS signal to your amplifier (receiver),
and press ENTER.
If your AV amplifier (receiver) has a DTS
decoder, select "On." Otherwise, select "Off."
17
Press ENTER when "Finish" appears.
Easy Setup is finished. All connections and
setup operations are complete.
EASY SETUP
Easy Setup is finished.
Finish
To return to the previous step
Press O RETURN.
z Hints
• If your AV amplifier (receiver) has an MPEG audio
decoder, set "MPEG" to "MPEG" (page 86).
• If you want to run Easy Setup again, select "Easy
Setup" in the Setup Display (page 90).
master page=left
5/5
5/5
RDR-GXD500
2-188-393-11(1)
Advertisement
Table of Contents
