Mounting - Siemens SINAMICS GL150 Operating And Installation Instructions

Mounting

Observe Chapter, "Safety instructions" when carrying out any work at the converter.
See also
Safety information (Page 15)
NOTICE
Improper installation
The devices can be damaged through improper installation.
Install the devices as described in the following sections. Take note of the ambient
temperatures stated in the technical specifications. Protect the drive against excessive stress
and loading.
Dirt deposits during installation
Dirt gets deposited in the open converter during installation work. Dirt deposits can lead to
the converter no longer fulfilling the requirements for cleanliness. If the converter is operated
with internal pollution, death, serious injury and material damage can result.
Therefore, remove dirt deposits after installation. Then keep the doors closed.
In the event of contamination from conductive dust particles (e.g. from welding work),
professional cleaning will be required. Contact the service center in this regard.
Defective seals
When working on the device, seals at the doors, roof panels as well as front, rear and side
panels can be damaged. Operating the device with defective seals can result in death, serious
injury or material damage.
Replace the defective seals before commissioning. Observe the environmental conditions
stated in the technical data.
SINAMICS GL150 6SL38503UM114PA0Z
Operating Instructions 04/2017
WARNING
WARNING
5
69