Transporting Transportation Units Packed In Boxes - Siemens SINAMICS GL150 Operating And Installation Instructions

Preparations for use
4.4 Transportation
4. To lift the transport unit, use single sling ropes or two ropes with a cross stitch. Attach the
5. Lift the cabinet. Avoid shifting the center of gravity or distorting or damaging the cabinet.
4.4.7

Transporting transportation units packed in boxes

Transportation with the fork-lift truck
Use of non-approved fork-lift trucks
If the forks are too short, this can cause the transportation unit/the device to tip over resulting
in death, serious injury, or damage inside the cabinet.
The forks of the truck must protrude at the rear of the transportation unit.
Only use forklifts approved for the purpose of transporting the devices.
Transportation with the crane
Standing under suspended loads
If the lifting gear or load suspension devices were to fail, the transportation unit/the cabinet
could fall. Death, serious injury, or material damage can result.
Do not stand underneath or near to a raised load.
To protect the boxes against pressure, use sufficiently long rope and a spreader beam. Please
proceed as follows:
1. Attach the rope/cable to the pallet as shown in the following diagram.
2. Attach the rope/cable to the spreader beam
62
crane rope to the lifting rods so it is close to the cabinet.
When suspended, the cabinet must be parallel to the ground.
WARNING
WARNING
①
and the crane hook.
SINAMICS GL150 6SL38503UM114PA0Z
Operating Instructions 04/2017