Information For Nominated Persons In Control Of An Electrical Installation; Proper Usage - Siemens SINAMICS GL150 Operating And Installation Instructions

2.7 Information for nominated persons in control of an electrical
installation
2.7.1

Proper usage

The converters are intended to be used as a stationary installation in closed and dry rooms
with a clean atmosphere. You can find the ambient and operating temperatures to be adhered
to in the technical data. If the described environmental conditions are not observed, warranty
claims and other claims may be rejected.
Explosions
If you operate the converter in a potentially explosive atmosphere, explosions can occur which
can cause death, serious injuries or material damage.
● Only operate the converter in a non-explosive environment (no hazardous zones).
Non-observance of proper usage
Improper use of the devices described can result in death, severe injury or material damage.
● Please observe all instructions for proper use.
The nominated person in control of an electrical installation must ensure that the following
points are observed:
● Follow the local and industry-specific safety and setup regulations. Observe the
● The operating instructions and the complete product documentation are always available
● The technical data as well as the specifications relating to the permissible installation,
● Only qualified personnel or personnel supervised by responsible, skilled specialists are
● During shipping, specific transport conditions are adhered to.
● Assembly is performed according to assembly instructions. Separate cabinet units are
● All instructions for EMC-compatible installation, cabling, shielding, grounding, and for
● Commissioning is only to be performed by qualified personnel trained for that purpose in
SINAMICS GL150 6SL38503UM114PA0Z
Operating Instructions 04/2017

2.7 Information for nominated persons in control of an electrical installation

WARNING
WARNING
requirements in the guidelines specified in the "Standards and regulations" section of the
"Technical data and drawings." Ensure that the specific safety and construction regulations
and the regulations for using personal protective equipment are observed during all work.
when carrying out any work.
connection, ambient and operating conditions are taken into account at all times.
allowed to carry out basic planning and all work on the converter.
connected properly (cables and busbars).
adequate auxiliary power supply are to be observed.
accordance with the commissioning instructions.
Safety information
21