Tools Required; Screwing The Transport Units Together - Siemens SINAMICS GL150 Operating And Installation Instructions

Mounting

5.1 Tools required

NOTICE
Foreign bodies in the drive
If, after installation and maintenance work, foreign bodies are left in the drive, this can damage
it when switching on.
Before switching on, check as to whether there are any foreign bodies in the drive. Remove
any foreign bodies.
NOTICE
Incorrectly opening the doors
If you incorrectly open the doors, then this can damage the locking mechanism.
Open the doors as described in Section "Preparing for use".
See also
Opening doors in preparation for use (Page 65)
5.1 Tools required
Installation of the connections requires the following tools:
● Wrench or socket wrench, width across the flats 10, 13, 16/17, 18/19
● Allen key, size 8
● Torque wrench up to 50 Nm
● Screwdriver, size 2
● Torx T20 and T30 screwdrivers
5.2

Screwing the transport units together

NOTICE
Stress
Stress that occurs during transport may exert mechanical pressure on the components.
Material damage can result.
● Line the cabinets up precisely with each other in order to avoid shearing forces when the
● Install the drive only on a level and horizontal surface.
70
base units are screwed together.
SINAMICS GL150 6SL38503UM114PA0Z
Operating Instructions 04/2017