Settings For The Sound (Audio Setup) - Sony DVP-NS90V Operating Instructions Manual

Notes
• When you set the item to "AUTO," the language
may change. The "TRACK SELECTION" setting
has higher priority than the "AUDIO" settings in
"LANGUAGE SETUP" (page 69).
• If you set "DTS" to "D-PCM" (page 75), the DTS
sound track is not played even if you set "TRACK
SELECTION" to "AUTO."
• If PCM, DTS, and Dolby Digital sound tracks
have the same number of channels, the player
selects PCM, DTS, and Dolby Digital sound
tracks in this order.
MULTI-DISC RESUME (DVD VIDEO/
VIDEO CD only)
Switches the Multi-disc Resume setting on or
off. Resume playback can be stored in
memory for up to 40 different DVD VIDEOs/
VIDEO CDs (page 30).
ON Stores the resume setting in
memory for up to 40 discs.
OFF Does not store the resume
setting in memory. Playback
restarts at the resume point only
for the current disc in the player.
Note
If you run Quick Setup, Multi-disc Resume settings
stored in memory may return to the default settings.
AUDIO (HDMI)
Selects the type of audio signal output from
the HDMI OUT jack.
AUTO
Normally, select this. Outputs
audio signals according to the
"DIGITAL OUT" settings
(page 74).
PCM
Converts Dolby Digital, DTS,
or 96 kHz/24 bit PCM signals to
48 kHz/16 bit PCM.
Note
A loud noise (or no sound) will be output if you
connect the player to a TV that is not compatible
with DOLBY DIGITAL/DTS signals and "AUTO"
is selected. In this case, select "PCM."
Settings for the Sound
(AUDIO SETUP)
"AUDIO SETUP" allows you to set the sound
according to the playback and connection
conditions.
Select "AUDIO SETUP" in the Setup
Display. To use the display, see "Using the
Setup Display" (page 68).
The default settings are underlined.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
AUDIO FILTER:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
DTS:
48kHz/96kHz PCM:
AUDIO ATT (attenuation)
If the playback sound is distorted, set this
item to "ON." The player reduces the audio
output level.
This function affects the output of the
following jacks:
– LINE OUT L/R (AUDIO) jacks
– 5.1CH OUTPUT jacks
OFF
Normally, select this position.
ON
Select this when the playback sound
from the speakers is distorted.
AUDIO DRC (Dynamic Range Control)
(DVD VIDEO/DVD-VR mode only)
Makes the sound clear when the volume is
turned down when playing a DVD that
conforms to "AUDIO DRC."
This function affects the output from the
following jacks:
– LINE OUT L/R (AUDIO) jacks
– 5.1CH OUTPUT jacks
– DIGITAL OUT (OPTICAL or COAXIAL)/
HDMI OUT jack only when "DOLBY
DIGITAL" is set to "D-PCM" (page 74).
STANDARD Normally select this position.
TV MODE Makes low sounds clear even if
you turn the volume down.
WIDE
Gives you the feeling of being
RANGE
at a live performance.
OFF
STANDARD
SHARP
DOLBY SURROUND
ON
D-PCM
D-PCM
48kHz/16bit
73
,continued