Settings For The Sound (Audio Setup) - Sony DVP-NS360 Operating Instructions Manual

Settings for the Sound
(AUDIO SETUP)
"AUDIO SETUP" allows you to set the sound
according to the playback and connection
conditions.
Select "AUDIO SETUP" in the Setup
Display. To use the display, see "Using the
Setup Display" (page 62).
The default settings are underlined.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
48kHz/96kHz PCM:
AUDIO ATT (attenuation)
If the playback sound is distorted, set this
item to "ON." The player reduces the audio
output level.
This function affects the output of the
following jacks:
– LINE OUT L/R (AUDIO) jacks
– LINE (RGB)-TV jack
OFF Normally, select this position.
ON Select this when the playback sound
from the speakers is distorted.
AUDIO DRC (Dynamic Range Control)
(DVD VIDEO/DVD-RW only)
Makes the sound clear when the volume is
turned down when playing a DVD that
conforms to "AUDIO DRC." This affects the
output from the following jacks:
– LINE OUT L/R (AUDIO) jacks
– LINE (RGB)-TV jack
– DIGITAL OUT (OPTICAL* or COAXIAL)
jack only when "DOLBY DIGITAL" is set
to "D-PCM" (page 68).
STANDARD Normally select this position.
TV MODE
Makes the low sounds clear
even if you turn the volume
down.
WIDE
Gives you the feeling of being
RANGE
at a live performance.
Switches the method for mixing down to 2
channels when you play a DVD which has
rear sound elements (channels) or is recorded
in Dolby Digital format. For details on the
rear signal components, see "Checking the
audio signal format" (page 44). This function
affects the output of the following jacks:
– LINE OUT L/R (AUDIO) jacks
– LINE (RGB)-TV jack
– DIGITAL OUT (OPTICAL* or
DOLBY
SUR-
OFF
ROUND
STANDARD
DOLBY SURROUND
ON
D-PCM
NORMAL
PCM
OFF
48kHz/16bit
Selects if audio signals are output via the
DIGITAL OUT (OPTICAL* or COAXIAL)
jack.
ON
OFF
* For DVP-NS585P/NS590P only
DOWNMIX (DVD VIDEO/DVD-RW only)
COAXIAL) jack when "DOLBY
DIGITAL" is set to "D-PCM" (page 68).
Normally, select this position.
Multi-channel audio signals are
output to two channels for
enjoying surround sounds.
Multi-channel audio signals are
downmixed to two channels for
use with your stereo.
DIGITAL OUT
Normally select this position. When
you select "ON," see "Setting the
digital output signal" for further
settings.
The influence of the digital circuit
upon the analog circuit is minimal.
67
,continued