Pto Wire; Dismantling; Checks; Assembly - Stiga VILLA 2000 Workshop Manual

Edition Manual
2008-05-19 Workshop Manual, Stiga Villa/Ready 6 Control wires

6.3 PTO wire

6.3.1 Dismantling

1. Lift the machine, either with a lifting table or
by highjack and pallets.
2. Open the engine casing.
3. Unscrew the cable adjustments, upper (A)
and lower (B).
4. Cut the holding strap (C) and unhook the
wire.

6.3.2 Checks

Check the brake shoe (D) for wear. If nesse-
cary replace it.

6.3.3 Assembly

1. Apply a couple of oil at the wire ends while
moving it in its conduit.
2. Assemble in the reverse order.
Warning!
If the wire is loose, it will interfere with
the steering wire. It is therefore espe-
cially important that it is locked with a
new holding strap correctly.
3. Replace the holding strap (C).
4. Adjust the wire. See below.

6.3.4 Adjustment

1. Set the cable adjustments, upper (A) and
lower (B) in their middle positions.
2. Adjust about the same amount at both
adjustments until the lever have a play of
3-3,5 cm.
3. Lock the adjustment nuts.
Chapter Page
3
A
D
B
C
3-3,5 cm