Assembly - Stiga VILLA 2000 Workshop Manual

Edition Manual
2008-05-19 Workshop Manual, Stiga Villa/Ready 3 Steering

3.1.3 Assembly

One single wire
1. Assemble the left wire part into the two left
steering pulleys (A and B). Fit the pulleys into
their respective place.
See "3.1.4 Steering pulleys".
2. Locate the wire in the recess (C) in the
steering disc and fasten with the screw. Use
a 13 mm wrench and a pliers to hold the wire
ends.
3. Turn the steering wheel until the wire rivet
hole is facing backwards and push in the
rivet.
4. Turn carefully the steering wheel 1,5 turn to
the left and simultaneously check that the
wire winds up correctly upwards on the drive
pulley.
Keep the left wire part stretched by blocking
or holding the rear wheels.
5. Assemble the right wire part into the two right
steering pulleys (A and B). Fit the pulleys into
their respective place.
See "3.1.4 Steering pulleys".
6. Turn the wire 1,5 turns to the right on the
drive pulley. Keep the wire stretched.
7. Keep the wire stretched and locate the wire
in the recess (D) in the steering disc and
fasten with the parts below. Use a 13 mm
wrench and a pliers to hold the wire ends.
• Spring
• Washer
• M8 self locking nut
Adjust the wire.
See "3.1.5 Adjusting the steering wire".
Chapter
B
B
Page
3
A C
A D