Edition
Manual
2008-05-19 Workshop Manual, Stiga Villa/Ready 3 Steering
3.2 Bearings, steering shaft
The steering shaft bearings consist of two slid-
ing bearings of the composite type (A and B).
3.2.1 Replacement of sliding bearings
1. Remove the steering wire or wires. See
"3.1.2 Dismantling".
2. Remove the stering wheel. See section 1.
3. If the machine is equipped with chain and
wire, release the chain from the sprocket.
4. Pull out the steering rod (F) downwards.
Don´t remove the washers and spacer (C, D
and E).
5. Replace the two bearings (A and B).
6. Assemble the steering rod (F) with its wash-
ers and spacer (C, D and E).
7. Assemble the stering wheel. See section 1.
8. Instructions for the chain, if applicable:
A. Apply a mark with a marking pencil at the
middle link of the chain (ev. there already
is a mark).
B. Turn the steering wheel to stright forward
position, i.e. the logo shall be correct
readable from the operators position.
C. Connect the chain to the sprocket with the
mark (G) backwards.
9. Assemble the steering wire or wires. See
"3.1.3 Assembly".
Chapter
A
B
C
D
E
F
G
Page
6