Epson TM-T88 Information Manual page 35

PRINT #1, CHR$(&H1B);"L";←
PRINT #1, CHR$(&H1B);"W";CHR$(0);CHR$(0);CHR$(0);CHR$(0);CHR$(180);
CHR$(0);CHR$(132);CHR$(3);
PRINT #1, CHR$(&H1B);"T";CHR$(0);←
PRINT #1, "AAAAA"; CHR$(&HA);←
PRINT #1, "BBBBB"; CHR$(&HA);←
PRINT #1, CHR$(&H1B);"T";CHR$(2);←
PRINT #1, "CCCCC"; CHR$(&HA);←
PRINT #1, "DDDDD"; CHR$(&HC);←
ESC T n
[Name] Select print direction in page mode
[Format] ASCII
Hex
Decimal
0 ≤ n ≤ 3
[Range]
48 ≤ n ≤ 51
ESC T n sets the print direction and starting position in page mode specified by n as shown below.
The default setting is n=0. This command is enabled only in page mode. If this command is
processed in standard mode, an internal flag is activated and this command is enabled when the
printer returns to page mode.
n Print Direction
0, 48 Left to right
1, 49 Bottom to top
2, 50 Right to left
3, 51 Top to bottom
The parameters for the horizontal or vertical motion units (x or y) differ depending on the starting
position of the printing area as follows:
If the starting position is the upper left or lower right of the printing area (n = 0, 2, 48, or 50):
These commands use horizontal motion units: ESC SP, ESC $, ESC \
These commands use vertical motion units: ESC 3, ESC J, GS $, GS \
1-26 Command Descriptions
Program Example
Select page mode
Select print direction
Store characters for printing
Store characters for printing
Select print direction
Store characters for printing
Batch print and return to standard mode
ESC T
1B 54
27 84
Starting Position
Upper left (A in the figure)
Lower left (B in the figure)
Lower right (C in the figure)
Upper right (D in the figure)
n
n
n
.
A
Printing area
Print Sample
AAAAA
BBBBB
←
Printing
area set
by ESC W
Rev. A