Epson TM-T88IV ReStick User Manual

All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior
written permission of Seiko Epson Corporation. No patent liability is assumed with respect to the use of the
information contained herein. While every precaution has been taken in the preparation of this book, Seiko
Epson Corporation assumes no responsibility for errors or omissions. Neither is any liability assumed for
damages resulting from the use of the information contained herein.
Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third
parties for damages, losses, costs, or expenses incurred by purchaser or third parties as a result of: accident,
misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or
(excluding the U.S.) failure to strictly comply with Seiko Epson Corporation's operating and maintenance
instructions.
Seiko Epson Corporation shall not be liable against any damages or problems arising from the use of any
options or any consumable products other than those designated as Original Epson Products or Epson
Approved Products by Seiko Epson Corporation.
EPSON is a registered trademark of Seiko Epson Corporation in Japan and other countries/regions.
NOTICE: The contents of this manual are subject to change without notice.
Standards and Approvals
The following standard is applied only to the printers that are so labeled. (EMC is tested using the
Epson power supplies.)
North America:
The connection of a non-shielded printer interface cable to this printer will invalidate the EMC
standards of this device. You are cautioned that changes or modifications not expressly approved by
Seiko Epson Corporation could void your authority to operate the equipment.
FCC Compliance Statement For American Users
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case
the user will be required to correct the interference at his own expense.
For Canadian Users
This Class A digital apparatus complies with Canadian ICES-003.
À l'intention des utilisateurs canadiens
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Default Delay Times for Power Management for Epson Products
This product will enter low power (sleep) mode after a period of nonuse. The time interval has been set at the
factory to ensure that the product meets Energy Star standards of energy efficiency and cannot be modified by
the consumer.
The power consumption in the sleep mode and power off mode when using the AC adapter PS-180 is
described below.
Sleep mode
AC 115V
60 Hz
Power off mode
FCC/ICES-003 Class A
WARNING
Serial model
1.2 W
0.3 W
© 2008 Seiko Epson Corporation
User's Manual
Parallel model USB model
1.4 W
0.3 W
1
Printed in China
Ethernet model
1.1 W 2.9 W
0.3 W 0.3 W