Epson TM-T88 Information Manual page 58

ESC @ initializes the printer. All settings, including character font and line spacing settings, are
canceled. The data in the print buffer is cleared and the printer mode is reset to the mode that was in
effect when the power was turned on. The DIP switch settings are not checked again, the data in the
receive buffer is not cleared, and any macro definitions are not cleared.
Program Example
PRINT #1, CHR$(&H1D);"!";CHR$(17);
PRINT #1, CHR$(&H1B);"E";CHR$(1);
PRINT #1, "AAAAA"; CHR$(&HA);
PRINT #1, CHR$(&H1B);"@"; ←
PRINT #1, "BBBBB"; CHR$(&HA);
GS I n
[Name] Transmit printer ID
[Format] ASCII
Hex
Decimal
1 ≤ n ≤ 3
[Range]
49 ≤ n ≤ 51
GS I n transmits the printer ID specified by n as follows. Each printer ID consists of 1 byte of data.
n Printer ID
1, 49 Printer model ID
2, 50 Type ID
3, 51 ROM version ID
Type ID
Bit Off/On Hex Decimal
0 Off 00 0
1 On 02 2
2 Off 00 0
3 Off 00 0
4 Off 00 0
5, 6 — — —
7 Off 00 0
Rev. A
TM-T88/T88P (TM-T85/T85P) Information Manual
Initialize printer
GS I
1D 49
29 73
Specification
TM-T88/T88P
TM-T85/T85P
See table below.
Depends on ROM version.
Function
Two-byte character code not supported.
Auto-cutter equipped.
Customer display not connected
Without MICR model
Not used. Fixed to Off.
Undefined.
Not used. Fixed to Off.
Print Sample
AAAAA
BBBBB ←
All settings are canceled after ESC @ is executed
n
n
n
ID (hexadecimal)
20 (decimal 32)
08 (decimal 8)
Command Descriptions 1-49