Installing The Camera Module - Bosch FLEXIDOME IP starlight 8000i Series Installation Manual

26 en | Hardware installation
5.3

Installing the camera module

1.
2.
3.
2019.07 | 02 |
Remove the camera module from the box.
– If necessary, install the SD card in SD slot 1.
– Press the SD card firmly until it latches into place in the slot.
– To remove the card, press it into the slot until it unlatches again.
– If more than one SD card is necessary, install the other SD card in SD slot 2.
Attach the camera module to the camera base and tighten the four screws between 2.5 to
4 Nm (1.8 and 3 lbfft). Make sure that the arrow on the camera module points in the
same direction as the red arrow on the camera base.
Remove the protective cover from the bubble.
Installation manual
FLEXIDOME IP starlight 8000i
Bosch Security Systems B.V.