Planning the installation
October 2018
1.3
Hazardous area installations
If your cable will be installed in a hazardous area, ensure that it meets the hazardous area
requirements.
Failure to maintain intrinsic safety in a hazardous area could result in an explosion.
To keep sensor wiring intrinsically safe:
•
Keep intrinsically safe (IS) sensor wiring separate from power supply wiring and output
wiring.
•
Do not install power cable in the same conduit or cable tray as flowmeter cable.
•
Use this document with the appropriate approvals documentation. These manuals are
shipped with the flowmeter or available on the Emerson web site: www.emerson.com.
•
For hazardous area installations in Europe, refer to standard EN 60079-14 if national
standards do not apply.
8
DANGER
Installation Manual
MMI-20001965
Micro Motion CSA-D-MVD Transmitter