Software Reset; No Response Settings; Delayed Response Settings - Panasonic CZ-256ESMC3 Technical Data Manual

Various procedures
(04–09) Software reset
[Reset method]
1 Press and hold the SET key for at least 1 second.
2 Reset is completed if all segments of the 7-segment numerical display light up.
(04–10) No response settings
• Sets whether to respond to request data from the communication adaptor control wiring.
[How to change]
1 Press and hold the SET key for at least 1 second and the setting value blinks.
2 Press the UP or DOWN key to change the setting value in the order of 0 → 1 → 2 → 3 → 0 → · · ·.
Setting value
0 (factory default)
1
2
3
3 Press and hold the SET key. When the display changes from blinking to lit, the change is completed.
4 Valid after power restart.
(04–11) Delayed response settings
• Send response data xx milliseconds after receiving data from the communication adaptor control wiring.
(xx: factory default is 20 milliseconds)
• Changing this setting may prevent communication with devices such as Intelligent Controller.
[How to change]
1 Press and hold the SET key for at least 1 second and the response delay time (milliseconds) will
blink.
2 Press the UP or DOWN key to change it to the delayed response time you want to set.
3 Press and hold the SET key. When the display changes from blinking to lit, the change is completed.
Display and settings for the communication adaptor board
HBS1
Responds
Responds
Does not respond
Does not respond
ー 25 ー
HBS2
Responds
Does not respond
Responds
Does not respond
(Changeable range: 0 to 99)