Table of Contents
Advertisement
5.10.2 14 - PRINT X-REPORT
This command is used to print the accumulators and counters, like the closure report, without writing
anything in the fiscal memory and can be executed at any time during the day.
5.10.2.1 Command Format
-----------------------------------------------------------------------
BYTE BIT CONTENT
0-1
1B66 - cmd prefix
2
14 - Print X-Report
3
Cmd. Extension
7-0 Reserved (always = ' 0 x00' )
-----------------------------------------------------------------------
5.10.2.2 Print X-Report Calculations
The calculations done during this command are the same as those done during the close sale period (13
cmd.) before the fiscal memory is written.
•
PLUS THE FOLLOWING IS ALSO DONE:
Day_N_X = Day_N_X + 1
Day_N_NFR = Day_N_NFR + 1
•
AND THE FOLLOWING ARE NOT DONE:
Lif_N_Clos = Lif_N_Clos + 1
The calculations done during the close sale period (13 cmd.) after the fiscal memory is written are NOT done
during this command.
5.10.2.3 Print X-Report Rules
•
If a PLD occurs when the report is printed, after the power-on, the stored lines in the buffer are printed
and the report is interrupted.
TYPE
LENGTH
hex
2
hex
1
hex
1
Command Set Reference — Page 121 of 183
Advertisement
Table of Contents
