Ff - Dump Ram & Fiscal Memory - IBM 4610 SureMark GR3 Programming Manual Supplement

5.12.7 FF - DUMP RAM & FISCAL MEMORY
This command is used to print the content of the RAM and fiscal memory in hexadecimal format.
5.12.7.1 Command Format
-----------------------------------------------------------------------
BYTE BIT CONTENT
0-1 1B66 - Cmd Prefix
2 FF - Dump RAM & Fiscal Memory
3 Cmd. Extension
Reserved (always = ' 0 ' )
7-5
4 Type Report
0 = Printed
1 = Electronic
Reserved (always = ' 0 ' )
3-1
0 Type
0 = RAM Memory
1 = Fiscal Memory
4-8 Start Address
9-13 End Address
14-17 Password
-----------------------------------------------------------------------
Notes:
memory address range is X'00000' - X' 0 FFFF'
1. The RAM
2. The fiscal memory address range is X'00000' - X' 7 FFFF'
Response for Electronic Dump will be formatted as follows:
5.12.7.2 Command Format
--------------------------------------------------------------------------------
BYTE BYTE CONTENT
RS-485 USB
0-8 Fiscal Unit Status
0-14 Fiscal Unit Status
9-218 15-224 Electronic Data
-----------------------------------------------------------------------
Notes:
1. The data are shown in a block of 210 bytes where valid are only those specified in the command,
the rest are padded with zeroes.
5.12.7.3 Dump RAM & Fiscal Memory Rules
•
This command can be issued with J4/CE jumper (FJUMPER flag) in ON or OFF position depending
of the type report.
TYPE LENGTH
hex 2
hex 1
hex 1
ASCII 5 (Note 1)
ASCII 5 (Note 2)
ASCII 4
TYPE LENGTH
hex 9
hex 15
hex 210 (Note 1)
Command Set Reference — Page 153 of 183