Table of Contents
Advertisement
BYTE
BIT
CONTENT
2
PRINTER UNIT STATUS
0 (LSB)
MEMORY SECTOR IS FULL
1
HOME ERROR
2
DOCUMENT ERROR
The document not inserted after document station was selected and the wait
timed out.
3
FLASH EPROM LOAD ERROR OR MCT LOAD ERROR
RESERVED (Always = ' 0 ' )
4
5
USER FLASH STORAGE SECTOR IS FULL
6
FIRMWARE ERROR
CRC on the firmware failed. The printer is running out of the boot sector.
ONLY system commands and firmware commands will be accepted.
7 (MSB)
FISCAL BIT
Set to show a line completed printing.
3
PRINTER UNIT STATUS
Contains the printer EC level with all status messages.
4
PRINTER UNIT STATUS
0 (LSB)
PRINTER ID REQUEST/EXTENDED ADDRESS CMD
Set to 1 when responding to a printer ID request.
1
EC LEVEL
Set to 1 when responding to an EC level request.
2
MICR READ
Set to 1 when responding to a MICR read command.
3
MCT READ
Set to 1 when responding to a MCT read command.
4
USER FLASH READ
Set to 1 when responding to a user flash read command.
Reserved (Always = ' 1 ' ) .
5
6
SJ COVER OPEN
Set to 1 when the cover in SJ station is open.
7
SJ STATION PAPER FAULT
Set to 1 when the paper is not present.
5
PRINTER UNIT STATUS
Contains the current line count the printer is on.
6
PRINTER UNIT STATUS
0 (LSB)
JOURNAL STATUS SELECTION
1 = Selected
0 = Not Selected
1
2
PDF417 BAR CODE GENERATION PROBLEM
Set to 1 when there is a problem creating a pdf417 bar code image.
3
CASH DRAWER STATUS
Set to 1 when cash draw is opened.
4
PRINTER KEY PRESSED
Set to 1 when a printer key operation is in progress.
RESERVED (Always = ' 1 ' )
5
6
STATION SELECTED
Set when the DI station is selected. Clear when the CR station is selected.
7 (MSB)
DOCUMENT FEED ERROR
Set when there is an error after a Flip Check or a MICR command is executed.
Figure 4. Printer and Fiscal Unit Status - GB3/GB5 Models - Part 2 of 3
(Note 1)
Printer and Fiscal Unit Status — Page 23 of 183
Advertisement
Table of Contents
