Interlogix Simon XTi-5 Version 2 User Manual page 6

When your system detects one of the problems above, six
rapid beeps sound every minute until the trouble condition is
corrected (depends on the security provider's configuration).
To stop the trouble beeps, enter the Status & Settings
screen and press "Listen". Trouble beeps will resume 4
hours later unless the trouble condition is corrected.
Note: Trouble Beeps can be configured to not occur during 8PM -
8AM or to only occur during that time if a communication
trouble occurs none other. It is therefore possible your
system may not trouble during those hours.
Programming
®
Your Simon XTi-5 (V2) security system allows you to
program certain user options, such as access codes.
To enter programming mode:
1. From the Status & Settings screen, scroll down to the
Programming option and press "Enter".
Enter the access code and press "OK".
2.
Access codes
To add/edit access codes:
From the Programming screen, press "ACCESS
1.
CODES".
2. To add or edit an access code, press the white field next
to the access code.
3. Enter the new/edited code on the numbered keypad and
press "SAVE".
4. Press the CLOSE icon repeatedly to exit menus.
Chimes
Use the chime feature to signal when a protected door is
opened while the system is disarmed. The panel chimes
when a chime sensor is tripped, if the chime mode is
enabled. This feature allows you to be notified when family
members are going in and out of your home. The chime
feature is turned on or off in the Status & Settings screen.
Note: If there are no chime sensors in your system, you will not be
able to enable the chime feature.
Your security provider may have programmed the system to
speak the sensor name or make a custom chime sound
when a chime sensor is tripped. The chime sound, if
programmed, will be played in place of the standard chime
beeps.
6 / 10
To enable or disable the chime feature:
1. Open the Status & Settings screen. The gold icon
indicates an option is selected.
2. To change the value, press ON or OFF icons next to
Chime (depending on the settings your security provider
has programmed, it may not be possible to turn on the
feature).
3. Press the Close icon to exit.
Special Chime
The special chime feature allows you to install motion
sensors in a patio or at the front door, and be notified when
someone is approaching those areas. These motion sensors
are not used for intrusion protection. The panel will chime, if
the special chime mode is enabled.
Note: If there are no sp ecial chime sensors in your system, the
special chime option will not appear in the Status & Settings
screen.
To enable or disable the special chime feature:
1. Open the Status & Settings screen. Scroll down until
you find the Special Chime feature. The gold icon
indicates an option is selected.
2. To change the value, press ON or OFF icons next to
Special Chime.
3. Press the Status icon to exit.
Cross-zoning
Cross zoning (two-trip) refers to two different motion sensors
that must be tripped within two minutes of each other to
report an alarm to the central station. The Cross-zoning
figure shows the path of a person walking from the kitchen to
the living room. When the person is detected walking
through the kitchen, the motion sensor in the kitchen is
tripped, sounding a local alarm. If motion is detected by the
living room motion sensor within two minutes, an alarm
report will be sent to the central station.
Figure 3: Cross-zone Diagram
P/N 466-5437 • REV A • 16OCT18