To Erase The Whole Disc; To Erase A Group - Sony MZ-B100 Operating Instructions (primary manual) Operating Instructions Manual

To erase a small section of a
track
Pause playback at the point where you
want to start erasing. Then do steps 1 and
2.
To erase a part of a track
Add track marks at the beginning and the
end of the part you want to erase, then
erase the part.

To erase the whole disc

Note that once a recording has
been erased, you cannot retrieve it.
Be sure to verify the contents of
the disc you want to erase.
1
Play the disc you want to erase, verify
its contents, and then press xSTOP.
2
While the recorder is stopped, press
ERASE.
"All Erase?" and "PushENTER"
appear alternately in the display.
3
Press . or > repeatedly until
" : Erase" flashes in the display,
and then press EDIT/ENTER.
Track name and "All Erase?" light up
and "PushENTER" flashes in the
display.
4
Press EDIT/ENTER.
"TOC Edit" flashes in the display,
and all the tracks will be erased.
When erasing is complete,
"BLANKDISC" appears in the
display.
To cancel erasing,
Press xSTOP.
40
-GB

To erase a group

Note that once a recording has
been erased, you cannot retrieve it.
Be sure to check the contents of
the group before you erase it.
1
Press GROUP for 2 seconds or more.
" " lights up in the display and the
group mode turns on.
2
Follow steps 1 and 2 of the procedure
described in "Selecting and playing
groups (Group skip mode)" (page 31)
to check the contents of the group you
want to erase. Then press xSTOP.
3
While the recorder is stopped, press
EDIT/ENTER, press . or >
repeatedly until "EDIT" flashes in the
display, and then press EDIT/ENTER
again.
4
Press . or > repeatedly until
" : Erase" flashes in the display,
and then press EDIT/ENTER.
The group name and "GP Erase?"
appear and "PushENTER" flashes in
the display. To cancel erasing, press
CANCEL.
5
Press EDIT/ENTER again.
The group is erased.
z
You can also use the SPEED CONTROL dial to
select and then enter the menu. Turn the dial
(instead of ./>) to show the menu items
one by one and press the dial (instead of EDIT/
ENTER) to enter the selected menu.