Sony MZ-B100 Operating Instructions (primary manual) Operating Instructions Manual page 12

3
Select the recording mode.
4
Record an MD.
built-in
microphones
xSTOP
Connect
firmly to i.
Connect firmly to i
To monitor the sound during recording.
Connect the supplied headphones with remote control to the i jack. You can adjust the volume by
turning the VOL control. This adjustment does not affect the recording level since the level is adjusted
automatically.
To
Record partway through the
previous recording
12
-GB
1
REC MODE
indicator
zREC
x
Press REC MODE repeatedly until "STEREO" lights
up in the display.
You can select normal stereo, LP2 stereo, LP4 stereo,
or monaural as the recording mode. For details, see
"Recording for long times" (page 16). The factory
setting is normal stereo.
The recording mode cannot be changed when
recording is in progress.
1
Press zREC.
"REC" appears, REC indicator lights
up, and then recording starts.
You can monitor the recording
conditions, such as the recording
position, through the display or the REC
indicator (page 26).
If the disc is blank, the recording
starts from the beginning. If the
disc is partially recorded, the
REC recording automatically starts
from the end of the existing
material.
To stop recording, press xSTOP.
After you press the xSTOP button to stop the
recorder, the recorder will automatically turn
off after about 10 seconds (when using an
alkaline dry battery) or 5 minutes (when using
the AC power adaptor).
Operation
Press NPLAY, >CUE/AMS or .REVIEW/
AMS to find the beginning of the material to be
recorded, and then press XPAUSE.
Press zREC so that the recorder changes to
recording pause.
Press XPAUSE again to start recording.