Installer Manual 255/LOGIX 742-762-764 - Installation
5.3.
Integration constraints
Location of a water treatment system is important. The following conditions are required:
•
level platform or floor;
•
room to access equipment for maintenance and adding brine (salt) to tank;
•
constant electrical supply to operate the controller;
•
total minimum pipe run to water heater of 3 m (10 ft) to prevent backup of hot water into system;
•
always install check valve to protect the softener from hot water return;
•
local drain for discharge as close as possible;
•
water line connections with shut off or bypass valves;
•
must meet any local and state codes for site of installation;
•
valve is designed for minor plumbing misalignments. Do not support weight of system on the
plumbing;
•
be sure all soldered pipes are fully cooled before attaching plastic valve to the plumbing.
32 / 92
Ref. MKT-IM-021 / A - 20.02.2019