Table of Contents
Advertisement
Installing the server and peripheral devices
Figure 6: Dongle installed on the server.
To install the software feature dongle
1. Ensure that there is nothing plugged into USB port 0 on the rear panel.
2. If the software feature key is not preinstalled in the dongle, insert it into the software
Figure 7: Dongle without feature key
3. To eject a software feature key, insert a straightened paper clip into the side access
40
Avaya CallPilot® 1005r Server Hardware Installation
feature slot on the dongle. Insert the software feature key with the data contact
facing down and away from the embossed i. See
key.
on page 41.
hole.
Push the paper clip in the direction of the software feature key.
Note:
In the following figure, label 1 is the data contact, and label 2 is the
ground.
Figure 8: Installing the. feature
December 2010
Advertisement
Table of Contents
