Table of Contents
Advertisement
To connect the mouse, keyboard, and monitor to the server
1. Place the monitor, keyboard, and mouse in the same location as the server.
2. Plug the keyboard and mouse cables into the PS/2 connectors on the rear panel
3. Plug the monitor into the video connector on the rear panel. Tighten the screws on
4. Ensure that a single-point ground reference is available for all the power outlets
5. Connect the power cord to the monitor and plug the other end into a wall receptacle
6. Turn on the monitor.
To connect the modem to the server
1. Connect one end of the telephone cable to the modem RJ-11 jack labeled LINE.
2. Connect the other end of the telephone cable to the RJ-11 jack in the wall.
3. Connect one end of the USB cable into the modem.
4. Connect the other end of the USB cable into either USB port 1 on the rear panel
To connect the external SCSI tape drive
Note : The external SCSI tape drive is a plug and play device. For a High availability system
you may wish to share one tape drive between the two servers.
1. Set the SCSI ID dial switch on the tape drive to SCSI ID 6.
2. With the power switch off, connect the external SCSI tape drive to the port labeled N
3. Plug the tape drive into the same single-point ground and A/C power as the rest of
4. Make sure the SCSI terminator is connected to the tape drive before powering on
5. Power on the tape unit.
Avaya CallPilot® 1005r Server Hardware Installation
(see Rear panel connectors).
the connector.
serving the CallPilot server and its peripherals. Before the CallPilot server
installation, a qualified electrician must implement the single-point ground reference
requirement between the power outlets of the CallPilot server and the power outlets
of the switch.
or power bar.
(long term) or USB port 2 on the front panel (short term).
on the rear panel. See Rear panel connectors.
the system.
the tape drive.
Rear panel connectors
December 2010
35
Advertisement
Table of Contents
