Table of Contents
Advertisement
Preparing for installation
Step
1
2
3
4
5
6
26
Avaya CallPilot® 1005r Server Hardware Installation
Review the "Installing the Avaya CallPilot server" section in the
Installation and Configuration Task List (NN44200-306), and
completed stage 1 of the "Installation checklist."
Unpack the server, and ensure you have all the items you need
(see
Unpacking the 1005r server
Complete the following checklists that are provided in the
Installation and Configuration Task List (NN44200-306):
• "CallPilot software media and documentation checklist"
• "CallPilot server hardware checklist"
Remove the front bezel and inspect the front panel (see pages
Removing the front bezel
Place the 1005r server in the chosen location (see
server
on page 31).
Replace the front bezel (see page
page 32).
Connect the 1005r server and devices as follows:
Connect the monitor, keyboard, and mouse (see
peripherals to the server
Connect the modem (see
server
on page 35).
Connect the 1005r server to the ELAN Ethernet switch or hub
(Meridian 1 or CS 1000 only) (see
the ELAN subnet
on page 37).
Important:
To comply with EMC radiation requirements, a Class A
Ethernet switch or hub must be located 10 m (33 ft.) away
from the 1005r server. Shielded Ethernet cables must be
used.
Note:
If you are connecting the optional Avaya server subnet, do
not power up unless your antivirus programs and Avaya
security updates are installed first.
Connect the 1005r server to the Avaya server subnet Ethernet
switch or hub (optional) (see
Avaya server subnet (optional)
Important:
To comply with EMC radiation requirements, a Class A
Ethernet switch or hub must be located 10 m (33 ft.) away
Description
on page 28).
on page 29).
To replace the front bezel
on page 34).
To connect the modem to the
Connecting the server to
Connecting the server to the
on page 38).
Check
Installing the
on
Connecting
December 2010
Advertisement
Table of Contents
