Table of Contents
Advertisement
Removing Interface and Electronics Modules
1. Press both release buttons above and below the interface or electronics module
at the same time.
2. Pull the interface or electronics module out of the terminal module towards the
front.
Figure 6-12 Removing Interface and Electronics Modules
Replacing a Defective Interface or Electronics Module
You have already removed the interface or electronics module:
1. Remove the two coding elements from the new interface or electronics module.
The coding elements are located on the bottom of the interface or electronics
module.
2. Insert the new interface or electronics module (of the same type) into the
terminal module until you hear it lock in place.
3. Label the new electronics module.
Note
Check the two coding elements before inserting the new electronics module in the
terminal module.
ET 200iS Distributed I/O Station
A5E00087831-02
1
2
1
Wiring
6-29
Advertisement
Table of Contents
