Chrysler Conquest 1988 Service Manual page 997

INTAKE AND EXHAUST SYSTEM
- Turbocharger
II-15
- O-ring
3EN23E
Chamfered
Snap ring edge
51NO24
UN07
SERVICE POINTS OF REASSEMBLY
NllLHAA
8. INSTALLATION OF O-RING
(1) Apply thin coat of engine oil to the inside of new O-ring
and insert it in the groove in cartridge assembly.
Caution
When O-ring is installed, be careful not to damage
O-ring. Otherwise, oil leaks may result.
(2) Apply thin coat of engine oil to the outside surface of
O-ring installed in cartridge assembly.
Then install cartridge assembly to compressor cover.-
Caution
When cartridge assembly is installed to compressor
cover, be careful not to damage vanes of cartridge
assembly.
6. INSTALLATION OF SNAP RING
Install snap ring with compressor cover side down.
Caution
Install snap ring with taper surface up.
INSTALLATION OF TURBINE HOUSING
(1) Place the compressor cover with cartridge assembly
inside on floor with its end surface down and install the
snap ring.
(2) Combine the compressor cover and cartridge assembly
with the turbine housing.
Caution
Do not damage the cartridge assembly vanes.
TEST OF WASTE GATE ACTUATOR OPERATION
NllLIAC
OPERATION CHECK OF WASTE GATE ACTUATOR
(1) Connect the tester to nipple "C". Open up nipple "A" to the
atmosphere.
(2) Plug nipple "B".
(3) Apply pressure to the actuator and check that the rod
moves.
Applied pressure value: Approx. 85 kPa (12.3 psi)
Caution
Do not apply a pressure of more than 100 kPa (14.5 psi)
to the actuator. Otherwise, diaphragm may be dam-
aged.
Never attempt to adjust the waste gete valve.