Chrysler Conquest 1988 Service Manual page 1016

Q-18
LUBRICATION AND MAINTENANCE
- Maintenance Service
04u001~
JOOOE
A
4
I
14K511
THERMOSTAT (Inspect)
(1) Remove the thermostat. _
(2) Replace the thermostat if-the valve is open-even- slightly: Ii.- 1: -
(3) Replace if greatly deformed, damaged or broken.
(4) Remove rust and fur fron-rthe valve if found on the valve. "T ' I'
(5) Fill a container with water and immerse the thermostat. I.,
y
I ~
While stirring water, increase water temperature and check
=
to see that thermostat valve opening temperature and
full-open temperature [valve lift at full open positiori.is 8 mm zzY E
(.3 in.) or more] are as specified below.
-- =-
-_.
Standard value:
=-
Valve opening temperature
=:~I
s-
88 Yl.5"C (190 5 3°F)
Full-open temperature 100°C (212°F)
s
NOTE
Sk
Valve lift is calculated by finding difference between the .i
EL:
E:
valve height measured at full-close state and <the valve __ ~_ E::,
height measured at full-open temperature.
_ ~~ mszf
Em--
REPLACE ENGINE COOLANT
-y"
(1) Set the temperature control lever to the hot position.
(2) Remove the radiator cap.
:. E
(3) Loosen the drain plug to drain the engine-coolant. .~ ...i
(4) Drain the engine coolant-from the reserve tank.
--
Lack: -: 3~
(5) After draining the engine coolant, tighten the drain $ug
mT=
securely.
s:
(6) Supply the engine coolantinto the radiator until it:is filled up .'~ .. ji c'
to its filler neck.
L_
(7) Supply the engine coolant into the reserve tat-&.
-~- i Ey
(8) After warming the engine until the thermos$& op&$ y- .. E
remove the radiator cap arid check the engine coolant level. _ ~_
G+
(9) Supply the engine coolant&to the radiator until it&.fjlledup ?_ _ _i E
to Its tiller neck, and rnstall the radiator cap sqcurely.
(1O)Fill the reserve tank wrth engine coolant up to the "FULL" 7 _
line.
Es=
DISC BRAKE PADS (Inspect for wear)
Check for fluid contaminationand wear. Replace complete set ;
of pads if defective.
Caution
The pads for the right and left wheels should be replaced at
the same time. Never "split" or intermix brake pad sets. All
four pads must be replaced as a complete set.
Thickness of lining (A):
Limit 2.0 mm (.08 in.)
-