Chrysler Conquest 1988 Service Manual page 1038

.--.".....
; .;~-;
3-20
REAR AXLE - Axle Shaft
AXLE SHAFT
DISASSEMBLY AND REASSEMBLY
-_L-.----
NOIHE- -
260-300
Nm
186-217
ftlbs.
q
i
Disassembly steps
I. Companion flange mounting nut (self-locking
nut)
4+ 2. Axle shaft
3. Spacer
4. Outer bearing
5. Dust cover
6. Companion flange
7. Dust cover
44 8.
Oil seal
NOTE
9. Inner bearing
(1) Reverse the disa&embly procedures toEassemble.
+I): Refer to "Service Points of Disassembly". (2)
IO. Axle housing (3) I)+: Refer to "Service Points of Reassembly",
11. Dust cover
(4)
q
: Non-reusable parts
--;
SERVICE POINT OF DlSiSSEMBLY
NOSWAA
2. REMOVAL OF AXLE SHAFT
Loosen the companion flange mounting nut, and then tap
the axle shaft out of the:axle housing by using-a plastic e
hammer.
Caution
Be careful not to scratch the oil seal.