Chrysler Conquest 1988 Service Manual page 1171

AUTOMATIC TRANSMISSION
- Specifications
21-49
SERVICE SPECIFICATIONS
NZlCB- -
Items
Standard Limit
Engine idle speed
rpm
850+100
-
Stall speed
wm
2,750-3,050
-
Direct clutch side plate clearance mm (in.) O-O.2 (O-.008)
-
High-reverse clutch clearance
mm (in.) 1.6-2.0(.063-.079)
-
Forward clutch clearance mm (in.) 0.8- 1.6(.031 -.063)
-
Low-reverse brake clearance
mm (in.) 0.80-1.25 (.031 -.049:
-
Front end play mm (in.) 0.5-0.8(.020-.031)
-
Front total end play mm (in.) 0.25-0.50(.010-.020) -
O.D. pack end play mm (in.)
0.5-0.8(.020-.031)
-
O.D. total end play mm (in.)
0.25-0.50 (.OlO-,020)
-
Clearance between oil pump outer gear and
0.14-0.21 (.0055-.0083) 0.25(.0098)
crescent ~mrn (in.1
Clearance between oil pump outer gear and
0.05-0.20(.0020- -0079) 0.25(.0098)
housing
mm (in.)
Oil pump gear end play mm (in.) 0.02 -0.04 (.0008-.0016) 0.08 (.0031)
TORQUE SPECIFICATIONS
NZlCC-.
ems
ransmission installation
Drive plate to crankshaft
Drive plate to torque converter
Converter housing to engine
omponent part
Converter housing mounting bolt
Rear extension mounting
Oil pan bolt
2nd servo piston retainer to transmission case
2nd piston stem (when adjusting band brake)
2nd piston stem lock nut
One-way clutch inner race tightening bolt
Control valve body mounting bolt
Lower valve body to upper valve body
O.D. servo cover to retainer
O.D. servo piston retainer to O.D. case
O.D. stem (when adjusting band brake)
O.D. stem lock nut
Governor tube
Nm
ft.lbs.
128-138
94-100
56-62 42-46
43-54 31-39
44-54 33-40
20-25
14-18
5-7 3.6-5.1
7-9
5-6
12-15 9-11
[Turn back three [Turn back
turns after three turns after
tightening]
tightening]
15-39
II-29
13-18 9-13
5.4-7.4
4.0-5.4
2.5-3.4
1.8 - 2.5
5-7 3.6-5.1
IO-15 7-11
7-10 5-7
15-39 II-29
15-18 II-13