Chrysler Conquest 1988 Service Manual page 1219

AUTOMATIC TRANSMISSION - Automatic Transmission Assembly
21-97
JAT154
Q--- Bearing race
Thrust washer
(Fiber)
JAT157
Available Oil Pump Cover Bearing Race
Thickness mm (in.)
Part number
1.2 f.047)
1.4 l.055)
1.6 (.063)
1.8 (.071)
2.0 (.079)
2.2 t.087)
17. Install brake band, band strut and band servo. Lubricate
servo O-rings before installing. Care should be taken to
avoid damaging O-rings when reassembling.
MD61 0221
MD61 0222
MD61 0223
MD61 0224
MD61 0225
MD61 0226
18. Install and torque the retainer bolts. Loosen piston stem.
Servo piston retainer bolt: 7 - 9 Nm (5 - 6 ft.lbs.)
19. Finger tighten brake band servo piston stem enough to
prevent brake band and strut from falling out. Do not adjust
brake band at this time.
20. Apply petroleum jelly to bearing race and thrust washer,
then mount them on drum support.