Chrysler Conquest 1988 Service Manual page 996

-
INTAKE AND EXHAUST SYSTEM
- Turbocharger
S
5lN022
3EN23
6
6. REMOVAL OF SNAP RING
Place the compressor cover assembly on floor with its end _
surface down and remove the snap ring with pliers.
1
Caution
During removal, hold with a finger the snap ring which
can spring out.
-
7. REMOVAL OF CARTRIDGE ASSEMBLY
Remove the cartridge ass@nbly by tapping the compressor 7
cover with a soft hammer.
Caution
Some resistance will be experienced in the removal due
to the O-ring on cartridge assembly.
INSPECTION
TURBOCHARGER
NllLGAA
(I) Inspect the cast-iron turbine housing for damage, cracks, or ~1
evidence of contact between the turbine blades and the 1
housrng.
(2) Manually open and close the waste gate valve to make sure 2
IT operates freely.
(31 Inspect the~turbine and -compressor wheels for wear, _
damage, bent or broken blades.
(4) Inspect the oil passage In the cartridge for signs of deposits !
or blockage.
(51 Clean the inlet sectron of the compressor cover with a rag.
-
Inspect rt for signs of contact with the compressorturbrne.
If worn, replace It. :
WASTE GATE ACTUATOR
(I 1 Leak-test the waste gate valve actuator with a hand pump.
Replace then actuator of -leakage Indicates a 'ruptured
diaphragm.
(2) Check the rodto see that It is not bent or binding so as-to
~1
require replacement, _