Chrysler Conquest 1988 Service Manual page 1253

WHEELS AND TIRES
- Wheel and Tire
22-5
WHEEL AND TIRE
NZZGA- -
REMOVAL AND INSTALLATION
Removal steps
1. Center cap
2. Wheel nut
3.
Wheel
4. Tire
5. Balance weight
NOTE
Reverse the removal procedures to reinstall.
90-I 10 Nm
cc onu IL-
I
"a-0" I L.,&J5.
1 lY&%
TIRE AND WHEEL ROTATION
Caution
NZZGE- -
1. Do not use the compact spare wheel in tire rotation. '
2. Do not rotate the tires because their front and rear
wheels/tires are different in size from each other.
Finger-tighten wheel nuts then use a torque wrench to tighten
the wheel nuts to specification.
NOTE
Do not use an impact wrench or apply oil to the wheel studs.
INSTRUCTIONS FOR ALUMINUM TYPE WHEELS
NZZGFAA
1.
2.
Aluminum is vulnerable to alkalies. If a vehicle washing
detergent has been used, or salt from sea water or road
chemicals has adhered, wash the vehicle as soon as
possible. After washing the vehicle, apply body or wheel
wax to
the aluminum type wheels to prevent corrosion.
When cleaning the vehicle with steam, do not direct steam
onto the aluminum type wheels.
When tightening nuts for aluminum type wheels, particular-
ly observe the following:
(1) Clean the hub surface of aluminum type wheels.
(2) After finger-tightening wheel nuts, tighten them to
specifications.
(3) Do not use an impact wrench or push the wrench by
foot to tighten the wheel nuts.
(4) Do not apply oil to the threaded portions.