Ricoh AP-P2 G188 Field Service Manual page 71

8. Put the side-to-side detection unit [G] in the machine. Make sure that the two pins are engaged
correctly at the front.
9. Make sure that the side-to-side detection unit moves smoothly on its rails. If it does not, make sure that
the rails are aligned with their grooves.
10. Attach the side-to-side detection unit and connect it at the rear ( x 2,
11. Pull the short connector out of the connector [H] then connect the cable of the finisher (
• This is the 3-pin connector.
12. At the front, use a pair of wire cutters to remove the part [I] of the cover.
13. Install the punch-waste transport unit [J] in the finisher.
14. Make sure that the punch-waste transport unit moves smoothly on its rails. If it does not, make sure
that the rails are aligned with the grooves.
Punch Unit (B702)
x 1, x 1).
x 1).
2
69